Altana Color-View Manuale Utente Scaricare il pdf (Pagina 52)

color-view™ Spectrophotometer User’s Guide

NOTE

It is important to remember not to touch the bulb or the inside

surface of the lamp reflector. Hand oils or dirt will cause

damage to these surfaces and render the lamp assembly useless.

8 Lift lamp out of its operation position and set on Sensor.

9 Locate end of lamp lead wires (yellow) which are

fastened to terminal block.

10 Loosen the retaining screws (which attach the wires to the

block) just enough so that the contact lugs can be easily

removed from under the screws. Do not completely

remove the screws from the block.

11 Remove the lamp from the compartment.

Replacement

1 Locate the spare replacement lamp in the accessory box.

2 Insert the contact lugs of the replacement lamp between

the screw head and the terminal block. Tighten the

screws to insure a good contact.

3 Insert the replacement lamp in the holder slot in the lamp

compartment and refasten wire spring.

4 Reinstall lamp compartment door.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 74 75

Nessun commento

Altana Color-View Manuale Utente Pagina 52